Dell PowerEdge M I/O Aggregator Reference Manual page 143
Dell poweredge ftos command line reference guide for the m i/o aggregator
Hide thumbs
Also See for PowerEdge M I/O Aggregator:
- Getting started manual (38 pages) ,
- Command reference manual (290 pages)
Table of Contents
Advertisement
Example
Figure 11-15. show config Command Example for the INTERFACE Mode
FTOS(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
FTOS(conf-if)#
show config (from INTERFACE RANGE mode)
Displays the bulk configured interfaces (group).
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command
Version 8.3.17.0
History
Example
Figure 11-16. show config (Bulk Configuration) Command Example
FTOS(conf)#interface range tengigabitethernet 1/1 - 2
FTOS(conf-if-range-tengig-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
!
interface TenGigabitEthernet 1/2
FTOS(conf-if-range-tengig-1/1-2)#
show config (from INTERFACE VLAN mode)
Displays
Syntax
show config
Command Modes
INTERFACE VLAN
Example
Figure 11-17. show config Command Example for the Default VLAN
FTOS(conf-if-vl-1)#show config
!
interface Vlan 1
FTOS(conf-if-vl-1)#
Command
Version 8.3.17.0
History
no ip address
switchport
no shutdown
Supported on M I/O Aggregator
no ip address
switchport
no shutdown
no ip address
switchport
no shutdown
the current configuration of the Default VLAN.
description a
no ip address
mtu 2500
shutdown
Supported on M I/O Aggregator
Interfaces | 141
Advertisement
Table of Contents
