Dell PowerEdge M I/O Aggregator Reference Manual page 208

Related
Commands
ssh
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
206 | Security
Table 1 describes the information in the
Table 1 show users Command Description
Field
(untitled)
Line
User
Host(s)
Location
ssh Enables a user.
Open an SSH connection specifying the hostname, username, port number and version of the SSH
client.
FTOS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound SSH
supports accessing the system through the management interface as well as through a physical Layer 3
interface.
ssh { hostname | ipv4 address
hostname
(OPTIONAL) Enter the IP address or the hostname of the remote device.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
-l username
(OPTIONAL) Enter the keyword
session.
Default: The user name of the user associated with the terminal.
-p port-number (OPTIONAL) Enter the keyword
Range: 1 to 65536
Default: 22
{ | }
(OPTIONAL) Enter the keyword
-v 1 2
Default: The version from the protocol negotiation
As above.
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Figure 19-5. ssh Command Example
FTOS#ssh 123.12.1.123 -l ashwani -p 5005 -v 2
show users command example.
Description
Indicates with am asterisk (*) which terminal line you are using.
Displays the terminal lines currently in use.
Displays the user name of all users logged in.
Displays the terminal line status.
Displays the IP address of the user.
} [ -l username | -p port-number
-l
-p
-v
| -v { 1 | 2 }]
followed by the user name used in this SSH
followed by the port number.
followed by the SSH version 1 or 2.