Dell PowerEdge M I/O Aggregator Reference Manual page 254

Defaults
Command Modes
Command
History
Example 1
252 | Debugging and Diagnostics
cpu data-plane statistics
cpu party-bus statistics
cpu private-mgmt
statistics
drops [ unit 0-0 [ port
1-56 ]]
stack-port 33-56
unit 0-0 { counters | details
| port-stats [ detail ] |
register }
none
EXEC
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Figure 25-5. show hardware stack-unit phy-firmware-version Command Example
FTOS#show hardware stack-unit 1 phy-firmware-version
PortNumber Status
=======================================================================
41 Present
42 Present
43 Present
44 Present
45 Not Present
46 Not Present
47 Not Present
48 Not Present
49 Present
50 Present
51 Present
52 Present
53 Present
54 Present
55 Present
56 Present
FTOS#
cpu data-plane statistics ,
Enter the keywords
keywords stack port and its number — 0 to 52 — to display the data plane
statistics, which shows the High Gig (Higig) port raw input/output counter
statistics to which the stacking module is connected.
cpu party-bus statistics
Enter the keywords
plane input/output counter statistics of the pseudo party bus interface.
cpu private-mgmt statistics
Enter the keywords
Management plane input/output counter statistics of the Private
Management interface.
drops
Enter the keyword to display internal drops on the selected stack
unit
member. Optionally, use the
port 1-56
then use to select a port on that port-pipe.
Enter this keyword and a stacking port number to select a stacking port for
which to display statistics. Identify the stack port number as you would to
identify a 10G port that was in the same place in one of the rear modules.
Note: You can identify stack port numbers by physical inspection of
the rear modules. The numbering is the same as for the 10G ports.
You can also inspect the output of the
command.
unit
Enter the keyword followed by 0 for port-pipe 0, and then enter one of
the following keywords to troubleshoot errors on the selected port-pipe and
to give status on why a port is not coming up to register level:
details , port-stats [ detail ], or register
Programmed Version
01.05
01.05
01.05
01.05
N/A
N/A
N/A
N/A
01.06
01.06
01.06
01.06
01.06
01.06
01.06
01.06
optionally followed by the
, to display the Management
, to display the
keyword with 0 to select port-pipe 0, and
show system stack-ports
counters ,
SW Version
01.05
01.05
01.05
01.05
N/A
N/A
N/A
N/A
01.06
01.06
01.06
01.06
01.06
01.06
01.06
01.06