U-Boot; Overview; Commands - Dell PowerEdge M I/O Aggregator Reference Manual

u-Boot

Overview

All commands in this chapter are in u-Boot mode. These commands are supported on the Dell Force10
Aggregator only.
To access this mode, hit any key when the following line appears on the console during a system boot:
Hit any key to stop autoboot:
You enter u-Boot immediately, as indicated by the

Commands

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note:
Only the most frequently used commands available in uBoot mode are described in
this chapter.
In uBoot mode, you cannot use the Tab key for command completion.
boot change
boot selection
boot show net config retries
boot write net config retries
boot zero
default gateway
enable
help
ignore enable password
ignore startup-config
interface management ethernet ip address
no default gateway
no interface management ethernet ip address
reload
show boot blc
show boot selection
show bootflash
show bootvar
show default gateway
show interface management ethernet
prompt.
BOOT_USER#
6
u-Boot | 79