Interface Vlan - Dell PowerEdge M I/O Aggregator Reference Manual

interface vlan

Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Example
Related
Commands
keepalive
Syntax
Defaults
Command Modes
Command
History
Usage
Information
136 | Interfaces
Configure the default VLAN to enable Static or DCHP IP configuration
interface vlan vlan-id
To delete a VLAN, use the no interface vlan
vlan-id
Enter 1 for the default VLAN.
Not configured
CONFIGURATION
Version 8.3.17.0 Supported on M I/O Aggregator
For more information about VLANs and the commands to configure them, refer to
(VLAN) Commands.
Figure 11-11. interface vlan Command Example
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
show vlan
vlan tagged
vlan untagged
Keep the interface alive when it is not transmitting data.
keepalive
Enabled
INTERFACE
Version 8.3.17.0 Supported on M I/O Aggregator
When you configure keepalive , the system keeps the link is up even if the link is not active at the time.
vlan-id command.
Displays the current VLAN configuration on the switch.
Adds a Layer 2 interface to a VLAN as a tagged interface.
Adds a Layer 2 interface to a VLAN as an untagged interface.
Virtual LAN