Dell PowerEdge M I/O Aggregator Reference Manual page 226

Example
Related
Commands
show system stack-unit iom-mode
Syntax
Command Modes
Command
History
show system stack-unit fanout
Syntax
Command Modes
Command
History
224 | Stacking Commands
Figure 21-4. show system stack-ports topology Command Example
FTOS#show system stack-ports topology
Topology: Daisy chain
Interface Connection
-----------------------------
0/33
0/37 1/37
1/33
1/37 0/37
FTOS#
Table 21-1. show system stack-ports Command Description
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone
Interface The unit/port ID of the connected stack port on this unit
Link Speed Link Speed of the stack port in Gb/s
Admin The only currently listed status is Up.
Status
Connection The stack port ID to which this unit's stack port is connected
power-cycle stack-unit
show diag
show system
Displays the current iom-mode (stack/standalone) and the mode configured after next reboot.
show system stack-unit <unit-number> iom-mode[configured]
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Displays the current 40GbE ports configured in fanout mode.
show system stack-unit <unit-number> fanout [configured]
EXEC Privilege
Version 8.3.17.0 Supported on M I/O Aggregator
Trunk
Group
Resets the designated stack member.
Displays the data plane or management plane input and output statistics of the
designated component of the designated stack member.
Displays the current status of all stack members or a specific member.