Show Interfaces Configured - Dell PowerEdge M I/O Aggregator Reference Manual

Figure 11-20. show interfaces ManagementEthernet Command Example
FTOS#show interface managementethernet ?
0/0
FTOS#show interface managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Pluggable media not present
Interface index is 235159752
Internet address is 10.11.209.87/16
Mode of IP Address Assignment : MANUAL
DHCP Client-ID: mgmt001ec9f10005
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 100 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d4h57m
Queueing strategy: fifo
Usage The interface counter "over 1023-byte pkts" does not increment for packets in the range 9216 > x <
Information
1023.
The Management port is enabled by default (no
to assign an IP address to the Management port.
Related

show interfaces configured

Commands
show interfaces port-channel
show interfaces switchport
show inventory
show ip interface
show memory
show interfaces status
show interfaces configured
Displays any interface with a non-default configuration.
Syntax show interfaces configured
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.17.0
History
Management Ethernet interface number
Current address is 00:1e:c9:f1:00:05
Input 3448753 packets, 950008323 bytes, 3442163 multicast
Received 0 errors, 0 discarded
Output 4627 packets, 814226 bytes, 0 multicast
Output 0 errors, 0 invalid protocol
Supported on M I/O Aggregator
show tdr). If necessary, use the ip address command
Displays any interface with a non-default configuration.
Displays information on all interfaces on a specific stack unit.
Displays Layer 2 information about the interfaces.
Displays the M I/O Aggregator type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
Displays Layer 3 information about the interfaces.
Displays the stack unit(s) status.
Displays all interfaces configured using the interface range command.
Interfaces | 145