Dell PowerEdge M I/O Aggregator Reference Manual page 145

Note:
maximum line rate. When the maximum line rate is reached, there will be no change in the
line-rate.
Example Figure 11-19. show interfaces Command Example for 10G Port
FTOS#show interfaces tengigabitethernet 2/0
TenGigabitEthernet 2/0 is up, line protocol is up
Hardware is Dell Force10Eth, address is 00:01:e8:05:f7:3a
Interface index is 100990998
Internet address is 213.121.22.45/28
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 02:31:45
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
Input 0 IP Packets, 0 Vlans 0 MPLS
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
Output Statistics:
1 packets, 64 bytes, 0 underruns
0 Multicasts, 2 Broadcasts, 0 Unicasts
0 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 00:00:27
Table 11-4. Lines in show interfaces Command Example
Line
TenGigabitEthernet 2/0...
Hardware is...
Interface index...
Internet address...
MTU 1554...
LineSpeed
ARP type:...
Last clearing...
Queuing strategy...
After the counters are cleared, the line-rate continues to increase until it reaches the
Description
Displays the interface's type, slot/port, and administrative and line protocol
status.
Displays the interface's hardware information and its assigned MAC address.
Displays the interface index number used by SNMP to identify the interface.
States whether an IP address is assigned to the interface. If one is, that address
is displayed.
Displays link and IP MTU information.
If the chassis is in Jumbo mode, this number can range from 576 to 9252.
Displays the interface's line speed.
Displays the ARP type and the ARP timeout value for the interface.
Displays the time when the
States the packet queuing strategy. FIFO means first in first out.
0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
show interfaces
counters where cleared.
Interfaces | 143