Dell PowerEdge M I/O Aggregator Reference Manual page 159

Command Modes INTERFACE
Command
Version 8.3.17.0
History
Usage
This command is found on the 1000/10000 Base-T Ethernet interfaces.
Information
When you enable auto , the system performs and automatic discovery to determine the optics installed
and configure the appropriate speed.
When you configure a speed for the 1000/10000 interface, you should confirm
Both sides of the link should have auto-negotiation either enabled or disabled. For speed settings of
1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting.
In FTOS, the command speed 1000 is an exact equivalent of speed auto 1000 in IOS.
Related
Commands
tdr-cable-test
Test the condition of copper cables on 100/1000/10GBase-T modules.
Syntax tdr-cable-test interface
Parameters
interface
Defaults
none
Command Modes EXEC
Command
Version 8.3.17.0
History
Usage The interface must be enabled to run the test or an error message is generated:
Information
FTOS#tdr-cable-test tengigabitethernet 5/2
%Error: Interface is disabled TenGIG 5/2
Related
show tdr
Commands
Supported on M I/O Aggregator
name
Supported on M I/O Aggregator
Enables or disables auto-negotiation on an interface.
GigabitEthernet
Enter the keyword Ten
information for the 100/1000/10GBase-T Ethernet interface.
Displays the results of the TDR test.
name command setting.
followed by the slot/port
Interfaces | 157