Dell PowerEdge M I/O Aggregator Reference Manual page 205

Parameters
encryption-type
password
Command Modes Not configured.
Command
Version 8.3.17.0
History
Usage Only Dell Force10 Technical Support staff use this command.
Information
enable smux-debug
Enable SMUX debug-level commands.
Syntax enable smux-debug
To disable SMUX debug, use n
Command Modes Not configured.
Command
Version 8.3.17.0
History
service password-encryption
Encrypt all passwords configured in FTOS.
Syntax
service password-encryption
To store new passwords as clear text, use the no service password-encryption command.
Defaults Enabled.
Command Modes
CONFIGURATION
Command
Version 8.3.17.0
History
(OPTIONAL) Enter the number
7
Enter
password that was already encrypted by a Dell Force10 router.
Use this parameter only with a password that you copied from the
running-config
Enter a text string, up to 32 characters long, as the clear text password.
Supported on M I/O Aggregator
o enable smux-debug
Supported on M I/O Aggregator
Supported on M I/O Aggregator
Caution:
Encrypting passwords with this command does not provide a high level of security.
When the passwords are encrypted, you cannot return them to plain text unless you re-configure
them. To remove an encrypted password, use the no password password command.
7
as the encryption type.
followed a text string as the hidden password. The text string must be a
file of another Dell Force10 router.
command.
show
Security | 203