Interface Range - Dell PowerEdge M I/O Aggregator Reference Manual

Dell poweredge ftos command line reference guide for the m i/o aggregator
Hide thumbs Also See for PowerEdge M I/O Aggregator:
Table of Contents

Advertisement

group
Syntax
Parameters
Defaults
Command Modes
Command
History
Example
Related
Commands

interface range

Syntax
Parameters
Defaults
Command Modes
132
|
Interfaces
Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group
group_number
port-channel number
none
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Version 8.3.17.0
Supported on M I/O Aggregator
Figure 11-2. group Command Example
FTOS(conf)#port-channel failover-group
FTOS(conf-po-failover-grp)#group 1 port-channel 1 port-channel 2
FTOS(conf-po-failover-grp)#
show interfaces port-channel
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
interface range interface , interface ,. ..
interface ,
Enter the keyword
..
port-channel or VLAN number. Select the range of interfaces for bulk configuration.
interface ,.
You can enter up to six comma separated ranges—spaces are not required between the
commas. Comma-separated ranges can include VLANs, port-channels and physical
interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5
tengigabitethernet 0/1-5
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a VLAN, enter the keyword
none
CONFIGURATION
group_number
Enter an integer from 1 to 32 that will uniquely identify this LAG
fate-sharing group.
port-channel
Enter the keyword
Enter this keyword/variable combination twice, identifying the two LAGs to
be paired.
Displays information on configured Port Channel groups.
interface range
and one of the interfaces — slot/port,
is not valid.
vlan
command.
followed by an existing LAG
interface range
is valid;
TenGigabitEthernet
followed by a number from 1 to 4094.
number
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge web serverPoweredge xl 5133-4

Table of Contents