Dell PowerEdge M I/O Aggregator Reference Manual page 161

vlan untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
interface
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
Version 8.3.17.0
History
Usage Untagged interfaces can only belong to one VLAN.
Information
In the default VLAN, you cannot use the no untagged interface command. To remove an untagged
interface from all VLANs, including the default VLAN, enter INTERFACE mode and use the
tagged
When two or more ports configured for VLANs form a LAG, the resulting LAG is a tagged member of
all the configured VLANs and an untagged member of the VLAN to which the port with the lowest
port ID belongs.
For example, if port 0/33 is an untagged member of VLAN 2 and port 0/41 is an untagged member of
VLAN 3, the resulting LAG consisting of the two ports is an untagged member of VLAN 2 and a
tagged member of VLANs 2 and 3.
Example Figure 11-35. VLAN Untagged Command Example
FTOS(conf-if-te-0/2)#vlan untagged ?
<1-4094>
FTOS(conf-if-te-0/2)#
FTOS(conf-if-te-0/2)#vlan untagged 4094
FTOS(conf-if-te-0/2)#show config
!
interface TenGigabitEthernet 0/2
!
!
FTOS(conf-if-te-0/2)#
Related
interface vlan
Commands
vlan tagged
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
Supported on M I/O Aggregator
command.
mtu 12000
vlan untagged 4094
port-channel-protocol LACP
port-channel 1 mode active
protocol lldp
advertise management-tlv system-name
dcbx port-role auto-downstream
no shutdown
Configures a VLAN.
Specifies which interfaces in a VLAN are tagged.
Untagged VLAN id
TenGigabitEthernet
no vlan
Interfaces | 159