Dell PowerEdge M I/O Aggregator Reference Manual page 151

Table 11-6. show interfaces port-channel Command Example Fields (continued)
Field
Output 0...
Rate information...
Time since...
Figure 11-24. show interfaces port-channel brief Command Example
FTOS#show int po 1 brief
Codes: L - LACP Port-channel
FTOS#
Table 11-7. show interfaces port-channel brief Command Example Fields
Field
LAG
Mode
Status
Uptime
Ports
(untitled)
Related
show lacp
Commands
show interfaces stack-unit
Displays information on all interfaces on a specific
Syntax
show interfaces stack-unit unit-number
Parameters
unit-number
LAG Mode Status
1 L3 down
Enter the stack member number (0 to 5).
Description
Displays the type and number of packets sent out the interface. This
information is displayed over three lines.
Displays the traffic rate information into and out of the interface. Traffic
rate is displayed in bits and packets per second.
Displays the time since the last change in the configuration of this
interface.
Uptime Ports
00:00:00 Te 0/16
Description
Lists the port channel number.
Lists the mode:
• L3 - for Layer 3
• L2 - for Layer 2
Displays the status of the port channel.
• down - if the port channel is disabled (shutdown)
• up - if the port channel is enabled (no shutdown)
Displays the age of the port channel in hours:minutes:seconds.
Lists the interfaces assigned to this port channel.
Displays the status of the physical interfaces (
In Layer 2 port channels, an * (asterisk) indicates which interface is the
primary port of the port channel. The primary port sends out interface
PDU.
In Layer 3 port channels, the primary port is not indicated.
Displays the LACP matrix.
M I/O Aggregator
(Down)
up down
or ).
stack member.
Interfaces | 149