Dell PowerEdge M I/O Aggregator Reference Manual page 140

name
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
138 | Interfaces
Table 11-2. monitor Command Menu Options
Key Description
m Change the view from a single interface to all interfaces on the stack unit or visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the interface to Bytes.
r Change the [delta] column from change in the number of packets/bytes in the last interval to
rate per second.
l Change the view to next interface on the stack unit, or if in the stack unit mode, the next
stack unit in the chassis.
a Change the view to the previous interface on the stack unit, or if the stack unit mode, the
previous stack unit in the chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.
Assign a name to the Default VLAN.
name vlan-name
To remove the name from the VLAN, use the no name command.
vlan-name
Enter up to 32 characters as the name of the VLAN.
Not configured.
INTERFACE VLAN
Version 8.3.17.0 Supported on M I/O Aggregator
This CLI applies only to the Default VLAN.
To display information about a named VLAN, enter the
or the show interfaces description
default vlan-id Assigns a descriptive text string to the interface.
interface vlan Configures a VLAN.
show vlan Displays the current VLAN configurations on the switch.
show vlan
command.
command with the name parameter