Installation is complete. You may now power up the disk array(s) and then the node as described in
Operation.
Installing VLS6800 Cables
1.
Connect Fibre Channel cables from your SAN media server to the node Fibre Channel host ports,
starting with Fibre Channel host port 0 and working towards Fibre Channel host port 3
37).
Leave the Fibre Channel loopback plug in any unused Fibre Channel host ports. This will prevent
you from receiving Fibre Channel notification alerts, which are generated by the VLS when no
signal is detected at a Fibre Channel host port.
Figure 37 Connecting SAN and LAN cabling to the node
.
Item
1
2
3
4
5
2.
Connect a standard Ethernet (CAT-5) cable from your local IP network (LAN) to the 10/100/1000
NIC 1 (RJ-45) connector
WARNING!
To reduce the risk of electric shock, fire, or damage to the equipment, do not plug telephone
or telecommunications connectors into RJ-45 (NIC) connectors.
Description
10/100/1000 NIC 1 connector
FC host port 0
FC host port 1
FC host port 2
FC host port 3
(Figure
37).
(Figure
HP StorageWorks
59