Power Supply Zone Fan Module; Installing An Ac Power Supply; Placing The Power Cord In The Strain Relief Clip - HP StorageWorks 6000 - Virtual Library System User Manual

1. Remove the protective cover from the connector pins on the power supply.
2. Slide the power supply into the bay until it clicks.
Figure 101 Installing an AC power supply
.
3. Use the strain relief clip to secure the power cord
Figure 102 Placing the power cord in the strain relief clip
.
4. Connect the power cord to the power supply.
5. Be sure that the power supply LED is green.

Power Supply Zone Fan Module

CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
1. Power off the node.
2. Extend or remove the node from the rack.
3. Remove the access panel.
4. Remove the SATA cable from the cable clip to avoid damaging the cable.
270 Component Replacement
(Figure 102).