Creating Cartridges; Create Virtual Library Wizard Window (8 Of 12) - HP StorageWorks 6000 - Virtual Library System User Manual

9. Choose one of the following options:
• To perform LUN mapping for the virtual tape drive, click Map LUNs and proceed to
"LUN Mapping
• To create more tape drives, click Create More Tape Drives.
• To add cartridges to the virtual library, click Create Cartridges and proceed to
"Creating
• To exit the wizard, click Cancel.
At this point the library and tape drives have been created, but the library does not contain
any cartridges. You can add cartridges later.

Creating Cartridges

To add cartridges to a virtual library:
1. If you are already in the Create Library Wizard window, select Create Cartridges.
The Cartridge Parameters window opens
2. If not:
a. Click the System tab.
b. Select the virtual library in the navigation tree to which you are adding cartridges.
c. Click Create Cartridge in the task bar.
The Cartridge Parameters window opens
Figure 74 Create Virtual Library Wizard window (8 of 12)
.
3. To add a barcode template:
a. Enter the barcode prefix (one to five alpha characters) in the Barcode Prefix box.
b. Enter the number of digits for the barcode number in the Digit Length box.
c. Enter the barcode suffix (one to two alpha characters) in the Barcode Suffix box.
d. Enter the starting barcode number in the Starting # box.
e. Click Add to add the new barcode template.
f. To add another barcode template, repeat these steps.
166 Configuration
(v3.x)" on page 153 for further instructions.
Cartridges" on page 166.
(Figure 74).
(Figure 74).