Item
1
2
3
4
5
6
7
5.
Rebooting the system is complete when you receive the "Initializing node#", then "Initializing for
node# completed." messages in the systems notifications.
Rebooting the System
To reboot the system from VLS CLI:
1.
Verify that any backup or restore operation has completed and that the VLS is idle.
2.
Open a secure shell session and log in as the administrator. See
"Opening a Secure Shell
3.
Initiate a reboot of the VLS by entering:
restartSystem
To reboot the system from Command View VLS:
1.
Verify that any backup or restore operation has completed and that the VLS is idle.
2.
Open a Command View VLS session and log in as the administrator. See
"Opening a Command View VLS Session from a Web
3.
Under the System tab, select Chassis in the navigation tree.
4.
Under Maintenance Tasks, select System Maintenance.
5.
Select Restart All Nodes from the task bar.
Restart Head Wizard displays.
6.
Select Yes to reboot all nodes.
CAUTION:
Rebooting the VLS device places the VLS cartridges back into the same library slots and tape drives
they were in at the time of reboot. To move the cartridges from tape drives back into the appropriate
slots, use Force Unload from the task bar visible when you select the tape drive from the navigation
tree.
Description
Internal health LED
External health LED (power supply)
Power supply power LEDs (green)
Power supply fault LEDs (amber)
Hard drive fault status LEDs
NIC 1 link LED
NIC 2 link LED
Session" on page 138.
Status
LED is green.
LED is green.
LEDs are illuminated.
LEDs are not illuminated.
LEDs are not illuminated.
LED is illuminated.
LED is off.
Browser" on page 135.
HP StorageWorks
129