Node Leds And Internal Health Led Combinations - HP StorageWorks 6000 - Virtual Library System User Manual

Item Description
11 Standby power good
12 Power supply fan module failure
13 System diagnostic
14 Online spare memory
15 Riser interlock

Node LEDs and Internal Health LED Combinations

When the internal health LED on the front panel of the node illuminates either amber or red, the node
is experiencing a health event. Combinations of illuminated system board LEDs and the internal health
LED indicate node status.
System board LED
and color
Processor failure,
socket X (Amber)
Processor failure,
both sockets (Am-
ber)
PPM failure (Amber)
DIMM failure, slot X
(Amber)
Internal Health
Status
LED Color
One or more of the following conditions may exist:
• Processor in socket X has failed.
• Processor in socket X failed over to the offline spare.
Red
• Processor X is not installed in the socket.
• Processor X is unsupported.
• ROM detects a failed processor during POST.
Amber Processor in socket X is in a pre-failure condition.
Red Processor types are mismatched.
Red PPM has failed.
• DIMM in slot X has failed.
Red • DIMM in slot X is an unsupported type, and no valid memory
exists in another bank.
Status
• Green = Auxiliary power is applied.
• Off = Auxiliary power is not applied.
• Amber = One fan in this module has failed.
• Red = Multiple fans in this module have
failed.
• Off = All fans in this module are operating
normally.
Refer to the HP Remote Lights-Out Edition II User
Guide.
• Amber = Failover has occurred. Online spare
memory is in use.
• Green = Online spare memory is enabled,
but not in use.
• Off = Online spare memory is disabled.
• Amber = PCI riser assembly is not seated.
• Off = PCI riser assembly is seated.
HP StorageWorks 221