Editing The Management Url; Uploading San Destination Library Or Tape Drive Firmware; Deploying San Destination Library Or Tape Drive Firmware - HP StorageWorks 6000 - Virtual Library System User Manual

2. From the task bar, select Scan.
The Destination Library Details screen refreshes, and the message, "Scan of destination library
successfully scheduled" displays.

Editing the Management URL

In order to view the management software for a SAN destination library from the Automigration
interface, provide the destination library URL:
1. From the navigation pane under Destination Libraries, select the library with the URL to add.
2. From the task bar, select Edit Management URL.
3. Type the URL into the Management URL field, then select Submit.
If the management URL is accepted, the Destination Library Details screen refreshes and displays
the message, "The management URL was successfully changed." If not, the Edit Management
URL screen refreshes and displays the error message, "Please enter a valid management URL."
4. If the URL is not changed, repeat this procedure using a valid URL.
After the Management URL has been successfully added, it creates a link to the management software.
Click on the URL in the Destination Library Details list to launch the management software in a new
window.

Uploading SAN Destination Library or Tape Drive Firmware

To load firmware for a physical library or disk drive to a destination library:
1. From the navigation pane, select the appropriate destination library or disk drive.
2. From the task bar, select Upload Firmware.
3. Select the firmware by either of these methods:
• Type the file name in the "Select file to upload:" field.
• Select Browse to locate the appropriate file.
4. Select Submit.
The SUMMARY FOR ALL DESTINATION LIBRARIES screen refreshes, along with the message, "File
[file name] successfully uploaded."

Deploying SAN Destination Library or Tape Drive Firmware

After uploading the firmware for a physical library or disk drive on a destination library (see
"Uploading SAN Destination Library or Tape Drive
1. Place the appropriate library offline (see
2. From the navigation pane, select the appropriate destination library or disk drive.
3. From the task bar, select Deploy Firmware.
4. From the DEPLOY LIBRARY FIRMWARE screen firmware list, select the firmware to install.
A dialog box displays to confirm the selection.
5. From the dialog box, select OK.
The Destination Library Details screen displays, along with the message, "File [filename]
successfully deployed."
102 Automigration/Replication
Firmware" on page 102), install the firmware:
"Placing a Library Offline or Online" on page 99).