Installing The Vls6100, Vls6200, Or Vls6500 Node Access Panel; Removing The Access Panel - HP StorageWorks 6000 - Virtual Library System User Manual

WARNING!
To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool
before touching.
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
CAUTION:
Electrostatic discharge can damage electronic components. Properly ground yourself before beginning
any installation procedure.
1. Power off the node. See
2. Extend the node from the rack. See
3. Unlock the access panel latch.
4. Lift up on the latch, and remove the access panel.
Figure 97 Removing the access panel
.

Installing the VLS6100, VLS6200, or VLS6500 Node Access Panel

1. Set the access panel on top of the node about a ¾ inch (0.2 inch for the VLS6200) from the
opening with the hood latch open.
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch.
4. Slide the access panel into the closed position.
266 Component Replacement
Powering Off the System.
Extending the VLS6800 Node from the Rack.