Installing The Shelves In The Rack; Installing The Module In The Rack; Aligning And Connecting Modules; Installing The Module Cables And Magazines - HP StoreEver MSL3040 User's And Service Manual

3. Repeat for the other rack shelf.
4. Using a #3 Phillips screwdriver, remove the screw holding the adapter block to the rack posts and then
remove the adapter block. Repeat for the remaining adapter blocks.

Installing the shelves in the rack

Procedure
Install the adapter blocks on the rack posts and then secure the rack shelves to the adapter blocks.
For instructions, see Installing the shelves in the rack.

Installing the module in the rack

Procedure
Install the module in the rack.
For instructions, see Installing a module in the rack
IMPORTANT:
Verify that the rack is level front to back and side to side before installing a module into the rack.
Racks that are not level can prevent the modules from aligning properly.

Aligning and connecting modules

Skip this step if the library does not have expansion modules.
Procedure
Engage the alignment mechanism and attach the module interconnect cables.
For instructions, see Aligning and connecting modules.

Installing the module cables and magazines

Procedure
1. Reattach any SAS, FC, and Ethernet cables removed earlier.
2. Insert any USB devices removed earlier.
3. Reattach the AC power cords.
4. Insert the magazines in the same locations they were removed from.
Installing the shelves in the rack 161