Controller Module; Removing The Disk Raid Controller Module - HP StorageWorks 6000 - Virtual Library System User Manual

Controller Module

1. Stop backup application data transfers.
2. Power off the disk array. See
3. Disconnect the SCSI cable from the VHDCI connector on the controller module.
4. Squeeze the release lever and the finger hook together while pulling the controller module out
of the disk array.
Figure 139 Removing the disk RAID controller module
.
5. Insert the replacement controller module into the disk array until it is firmly seated in the disk
array.
6. Connect the SCSI cable to the VHDCI connector on the controller module.
CAUTION:
To prevent damage to the VHDCI connector, do not use excessive force when tightening the
thumbscrews on the connector.
7. Confirm that the status LED on the replacement module is illuminated green.
8. Power on the disk array. See
9. Power on the node. See
Powering Off VLS6000 Disk
Powering on VLS6000 Disk
Powering on the VLS6000 series
Arrays.
Arrays.
System.
HP StorageWorks 299