Install Rails In The Rack; Attach Rails To The Vls6600 Node (Appliance); Attaching The Rear Bracket Of The Slide Rail To The Rack - HP StorageWorks 6000 - Virtual Library System User Manual

NOTE:
Allow enough rack space above and/or below the node to mount the disk arrays. A disk array
requires a vertical rack space of 2U (equivalent to 89 mm, or 3.5 inches).
To install a VLS6600 node into the rack involves three main tasks:
1.

Install Rails in the Rack

2.

Attach Rails to the VLS6600 Node (appliance)

3. Install Appliance in the Rack
Install Rails in the Rack
To install the rails in the rack:
1. Locate the appropriate rail kit—part number 365517-B21.
2. Install the two slide rails in the rack.
a. Locate the slide rail with the words REAR LEFT and align it with the rear of the left side of
the rack as you face the front of the rack.
b. Adjust the slide rail assemblies to the approximate rack depth.
c. From the outside rear of the rack, insert the screws of the slide rail rear bracket into the
appropriate holes in the rack and pull the rail forward until the rear bracket of the rail snaps
into place.
Figure 7 Attaching the rear bracket of the slide rail to the rack
.
d. From the outside front of the rack on the left rail, insert the screws of the slide rail front bracket
into the appropriate holes in the rack and push the rail back until the front bracket of the
rail snaps into place.
e. Repeat these steps with the right bracket on the right side of the rack.
Attach Rails to the VLS6600 Node (appliance)
To attach the rails to the appliance:
38 Hardware Installation