Power Supply; Pressing Ejector Button; Installing The Dvd-Cd Drive - HP StorageWorks 6000 - Virtual Library System User Manual

2. Press the ejector button in firmly until the DVD-CD drive ejects (1).
Figure 109 Pressing ejector button
.
3. Pull the DVD-CD drive out of the node (2).
To replace the component:
1. Carefully align the connector on the rear of the drive with the connector on the DVD-CD drive
interface board.
2. Slide the drive into the bay until it clicks.
Figure 110 Installing the DVD-CD drive
.

Power Supply

CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
HP StorageWorks 275