Class B Equipment; Modifications; Cables; Declaration Of Conformity For Products Marked With The Fcc Logo - HP StorageWorks 1/16 Tape SuperLoader Manual

Table of Contents

Regulatory Compliance Notices

Class B Equipment

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

The FCC requires the user to be notified that any changes or modifications made

to this device that are not expressly approved by Hewlett-Packard Company may

void the user's authority to operate the equipment.

Connections to this device must be made with shielded cables with metallic

RFI/EMI connector hoods in order to maintain compliance with FCC Rules and

Regulations.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

110

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

Consult the dealer or an experienced radio or television technician for help.

1/16 Tape SuperLoader Reference Guide

Table of Contents