Installing The Vls6600 Node Access Panel; Installing The Vls6800 Node Access Panel; Vls6100 And Vls6500 Node Component Replacement; Sata Hard Drive - HP StorageWorks 6000 - Virtual Library System User Manual

Installing the VLS6600 Node Access Panel

1. Set the access panel on top of the node about a 1/2 inch from the opening with the hood latch
open.
2. Push down on the hood latch.
3. Slide the access panel into the closed position.
4. Use the T-15 Torx screwdriver attached to the rear of the node to tighten the security screw on
the hood latch.

Installing the VLS6800 Node Access Panel

1. Place the access panel on top of the node with the latch open. Allow the panel to extend past
the rear of the node approximately 1.25 cm (0.5 inches).
2. Push down on the latch.
3. Slide the access panel into the closed position.

VLS6100 and VLS6500 Node Component Replacement

SATA Hard Drive

CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
NOTE:
SATA hard drive LED functionality and hot-plug capability are not currently supported.
1. Power off the node. See
2. Press the drive latch release button (1).
Powering Off the System.
HP StorageWorks 267