Vls6200 Node Component Replacement; Sata Hard Drive; Removing A Node Hard Drive; Preparing The Node Hard Drive - HP StorageWorks 6000 - Virtual Library System User Manual

NOTE:
DIMMs do not seat fully if turned the wrong way.
When replacing a DIMM, align the DIMM with the slot and insert the DIMM firmly, pressing down
until the DIMM snaps into place. When fully seated, the DIMM slot latches lock into place.

VLS6200 Node Component Replacement

SATA Hard Drive

CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Press the drive latch release button (1).
2. Pull the hard drive (3) out of the node by the latch handle (2).
Figure 106 Removing a node hard drive
.
To replace the component, pull out the latch handle (2) out as far as it can go and slide the drive into
the bay until the latch mechanism engages the chassis. Then, firmly push in the latch handle to lock
the drive in the drive bay.
Figure 107 Preparing the node hard drive
.
HP StorageWorks 273