Output Commands; Vls Commands; Network Settings Configuration Commands; Cli Output Commands - HP StorageWorks 6000 - Virtual Library System User Manual

Command
close
getHost
connect

Output Commands

Use the CLI commands in
the CLI commands.
Table 7 CLI output commands
Command
trace
verbose
version
help
enableVlsLog
disableVlsLog

VLS Commands

This section describes the VLS commands in the VLS CLI command set.

Network Settings Configuration Commands

Use the CLI commands in
settings via a serial session. See
Changing the network configuration parameters modifies four system files:
/etc/hosts
/etc/sysconfig/network
202 CLI Command Set
Description
Closes the connection to the VLS.
Displays the fully qualified name of the VLS and its IP address.
Connects to a host. Where <-tag> can be:
-a<s> - Host name (localhost is default) (optional)
-p<s> - Password (optional)
-u<s> - userid (optional)

CLI output commands

to control the output and display help information for
Description
Displays the stack trace after an exception has occurred.
Toggles verbose output on and off. When on, all messages are output to the screen.
Indicates current CLI version. If verbose is on, the module revisions display also.
Displays CLI command usage information. Where <-tag> can be:
-c<command> - Provides help information for the specified CLI command.
-all - Lists all CLI commands and their help information.
Enables VLS logging. Where the options are:
-d<n> - Debug level (1 to 9) (optional)
-h - Displays command usage information (optional)
Disables VLS logging. Where the options are:
-d<n> - Debug level (1 to 1) (optional)
-h - Displays command usage information (optional)

CLI network settings configuration commands

"Opening a Serial
to configure the VLS network
Session" on page 139.