Creating A Lan/Wan Replication Target - HP StorageWorks 6000 - Virtual Library System User Manual

3. If the library on which you want to add a LAN/WAN replication target appears in the list, select
that library. The Summary for all LAN/WAN Replication Targets screen displays all LAN/WAN
replication targets created for that library.
If the library does not appear in the navigation pane, it means that the library does not yet have
any LAN/WAN replication targets on it. Select LAN/WAN Replication Targets in the navigation
pane instead. The Summary for All LAN/WAN Replication Targets screen displays all LAN/WAN
replication targets created for all libraries.
4. Select Create LAN/WAN Replication Target from the task bar to open the Create LAN/WAN
Replication Target screen.
5. Enter a name for the LAN/WAN replication target. See
Figure 50 Creating a LAN/WAN replication target
.
6. If you did not select your library from the navigation pane, select the library on which you want
to add the target from the Local Library pull-down field.
The Available Slot Ranges section indicates the slots that are available on the library you just
selected.
NOTE:
If you selected your library from the navigation pane, this pull-down field does not appear
because you have already selected the appropriate library.
7. Enter a start slot and an end slot for the copy pool from within the available ranges.
8. Enter the number of maximum simultaneous transfers permitted.
This allows you to limit the replication activity on that target. This field defaults to the maximum
number of transfers allowed by the VLS.
9. Select a Compress option from the pull-down field.
The options are Global Setting, Yes (compression is on), and No (compression is off). See
"Setting the Global LAN/WAN Replication Target Configuration
global default.
10. Enter a registration password, and then retype it in the next field.
Figure 50.
Settings" on page 109 to set the
HP StorageWorks 107