Connecting The Scsi And Power Cables - HP StorageWorks vs80 User Manual

Connecting the SCSI and Power Cables

Figure 8
Attaching SCSI and Power Cables
Chapter 1
To connect the SCSI and power cables to the autoloader, follow these steps:
1. Shut down and turn off the selected server. Turn off all attached accessory
devices, such as printers and other SCSI devices. Remove the power cables
from the server and all attached accessories.
Caution Failure to remove the power cables from these devices could
result in damage to the autoloader.
2. Attach one end of the SCSI cable (included in the accessory kit) to one of
the connectors on the rear panel of the autoloader.
3. Attach the other end of the SCSI cable to the connector on the SCSI host
adapter or to the connector on the previous device on the SCSI bus.
Note If the supplied SCSI cable does not fit the connector on your SCSI
host adapter, you either have an incompatible SCSI host adapter
or you need to purchase a cable adapter. Contact your service
representative or your SCSI host adapter manufacturer for
information.
Installing the Autoloader 19