Chapter 5 Fabric Manager Client; Fabric Manager Advanced Mode; Launching Fabric Manager Client In Cisco San-Os Release 3.2(1) And Later - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Launching Fabric Manager Client in Cisco SAN-OS Release 3.2(1) and Later

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Fabric Manager Advanced Mode

Advanced mode is enabled by default and provides the full suite of Fabric Manager features, including
security, IVR, iSCSI, and FICON. Uncheck the Advanced check box in the upper right corner of the
Fabric Manager Client to simplify the user interface. In this mode, you can access basic MDS 9000
features such as VSANs, zoning, and configuring interfaces.
Launching Fabric Manager Client in Cisco SAN-OS Release
3.2(1) and Later
Note As of Cisco SAN-OS Release 3.2(1), the Fabric Manager Client login procedure has changed. If you are
running a version of Cisco SAN-OS that is earlier than Cisco SAN-OS 3.2(1), follow the login
instructions in the
page A-1
page
Network administrators must initially launch Fabric Manager Client using Fabric Manager Web Server,
Note
as described below. Once an administrator has installed the Fabric Manager Client icon on your desktop,
you can double click on the icon to launch the Fabric Manager Client.
To launch Fabric Manager Client, follow these steps:
Open your browser and enter the IP address where you installed Fabric Manager Server, or enter
Step 1
localhost if you installed Fabric Manager Server on your local workstation.
You see the Fabric Manager Web Server Login dialog box shown in
Figure 5-1
Cisco MDS 9000 Family Fabric Manager Configuration Guide
5-2
"Setting the Seed Switch in Cisco SAN-OS Releases 3.1(1) to 3.2(1)" section on
or the "Setting the Seed Switch in Releases Prior to Cisco SAN-OS Release 3.1(1)" section on
A-3.
Fabric Manager Web Server Login Dialog Box
Chapter 5 Fabric Manager Client
Figure 5-1.
OL-8007-10, Cisco MDS SAN-OS Release 3.x