Cisco WS-C6506 Software Manual page 966

Configuring Authentication on the Switch
Clearing RADIUS Servers
To clear one or more RADIUS servers, perform this task in privileged mode:
Task
Step 1 Specify the IP address of the RADIUS server to
clear from the configuration. Enter the all
keyword to clear all of the servers from the
configuration.
Step 2 Verify the RADIUS server configuration.
This example shows how to clear a single RADIUS server from the configuration:
Console> (enable) clear radius server 172.20.52.3
172.20.52.3 cleared from radius server table.
Console> (enable)
This example shows how to clear all RADIUS servers from the configuration:
Console> (enable) clear radius server all
All radius servers cleared from radius server table.
Console> (enable)
Clearing the RADIUS Key
To clear the RADIUS key, perform this task in privileged mode:
Task
Step 1
Clear the RADIUS key.
Step 2
Verify the RADIUS configuration.
This example shows how to clear the RADIUS key and verify the configuration:
Console> (enable) clear radius key
Radius key cleared.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
39-32
Command
clear radius server [ip_addr | all]
show radius
Command
clear radius key
show radius
Console Session Telnet Session
---------------- ----------------
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Telnet Session
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Chapter 39 Configuring the Switch Access Using AAA
OL-8978-04