Cisco WS-C6506 Software Manual page 1107

Chapter 44 Configuring Network Admission Control
Clearing a Policy Group from a Policy Template
To clear a policy group from a policy template, perform this task in privileged mode:
Task
Clear a policy group from a policy template.
This example shows how to clear a policy group from a policy template:
Console> (enable) clear policy name pol1 group grp1
Cleared group grp1 from policy template pol1.
Console> (enable)
Displaying Policy Group Information
To display policy group information, perform this task in normal mode:
Task
Display policy group information.
This example shows how to display policy group information:
Console> (enable) show policy group all
Group Name
Group Id
No.of IP Addresses = 3
Src Type
--------------------------------------------------
Group Name
Group Id
No.of IP Addresses
Src Type
Console> (enable)
OL-8978-04
= grp1
= 1
= ACL CLI
List of Hosts in group.
-----------------------
Interface = 0/0
IpAddress = 100.1.1.1
Src type = CONFIG
Interface = 0/0
IpAddress = 100.1.1.2
Src type = CONFIG
= grp2
= 0
= ACL CLI
Configuring Network Admission Control with LAN Port IP
Command
clear policy name policy-name group group-name
Command
show policy group {all | group-name}
= 2
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
44-23