Cisco WS-C6506 Software Manual page 1343

Chapter 53 Using Automatic QoS
Do you want to continue (y/n) [n]? y
........................
Autoqos ACL 'ACL_IP-SOFTPHONE-3-2' successfully deleted.
Autoqos ACL 'ACL_IP-SOFTPHONE-3-3' successfully deleted.
Autoqos ACL 'ACL_IP-SOFTPHONE-3-4' still mapped to port or vlan.
Autoqos ACL 'ACL_IP-SOFTPHONE-3-5' still mapped to port or vlan.
Autoqos ACL 'ACL_IP-SOFTPHONE-3-6' still mapped to port or vlan.
Cleared Autoqos policer 'POLICE_SOFTPHONE-DSCP46-3-2'
Cleared Autoqos policer 'POLICE_SOFTPHONE-DSCP24-3-2'
Cleared Autoqos policer 'POLICE_SOFTPHONE-DSCP46-3-3'
Cleared Autoqos policer 'POLICE_SOFTPHONE-DSCP24-3-3'
Could not clear Autoqos policer ''POLICE_SOFTPHONE-DSCP46-3-4', still in use.
QoS is disabled.
All ingress and egress QoS scheduling parameters set to factory default.
CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps
configured.
Console> (enable)
Tracking the QoS Configuration
A configuration "comment" appears in the configuration file to help you determine where the QoS
configuration originated: Traditional QoS or automatic QoS. The comment is created after you enter the
global set qos autoqos command and remains in the configuration file until you enter either the clear
global autoqos command or the clear qos config command. An example is as follows:
Console> (enable) set qos autoqos
..............
All ingress and egress QoS scheduling parameters configured on all ports.
CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps
configured.
Console> (enable) show config
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default configurations.
.................
...............................
............................
..
begin
<snip>
#qos – qos configuration via autoqos
set qos enable
set qos map 2q2t tx 2 1 cos 1
set qos map 2q2t tx 2 1 cos 2
<snip>
Console> (enable) clear qos autoqos
Its highly recommended to execute clear port autoqos commands prior
to the global clear command:
Do you want to continue (y/n) [n]? y
........................
No Autoqos ACLs found.
No Autoqos aggregate policer(s) found.
OL-8978-04
Global Autoqos QoS cleared.
Global QoS configured, port specific autoqos recommended:
set port qos <mod/port> autoqos trust <cos|dscp>
set port qos <mod/port> autoqos voip <ciscoipphone|ciscosoftphone>
clear port qos <mod/port> autoqos
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Using the Automatic QoS Macro on the Switch
53-17