Cisco WS-C6506 Software Manual page 659

Chapter 21 Configuring GOLD
Not all functional test groups are present for every module because the supported functional test groups
Note
vary depending on the module type. If you are not sure which functional test group to select, run all the
packet switching tests that are run during bootup when the diagnostic level is set to "complete" by
entering the diagnostic start module mod/num test complete command.
Note If you run the loopback test and it fails on one or several ports of a module, disconnect any cables that
are connected to the ports on that module, shut down all the ports on that module, and then rerun the
loopback test. It is possible that some spurious packets are interfering with the loopback test and causing
it to fail. Also, if the module has an inline-power daughter card, disable power to the inline-power
daughter card before running the test.
Additional test requirements are as follows:
User actions before running the test—None
•
User actions after running the test—None
•
Table 21-1
Functional Test Group
Per-port tests
Layer-2 forwarding tests
NetFlow function
ACL/QOS function
IP version 4 function
Multicast function
SPAN function
Fabric connection
EOBC connection
Packet Buffer issues
OL-8978-04
On-Demand Tests: Supervisor Engine
Individual Tests
TestLoopback
TestNewIndexLearn
TestMatchCapture
TestDontConditionalLearn
TestProtocolMatchChannel
TestBadBpduTrap
TestNetflowInlineRewrite
TestAclPermit
TestQosTcam
TestAclDeny
TestIPv4FibShortcut
TestFibDevices
TestL3Capture2
TestNATFibShortcut
TestL3VlanMet
TestIngressSpan
TestEgressSpan
TestFabricSnakeForward
TestFabricSnakeBackward
Proceed to Step 3
Proceed to Step 4
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring Online Diagnostics
21-5