Cisco WS-C6506 Software Manual page 1156

Chapter 47 Configuring SNMP
Configuring SNMPv3 on the Switch
This example shows how to set the access rights for a group called guestgroup to SNMPv3
authentication-read mode:
Console> (enable) set snmp access guestgroup security-model v3 authentication read
interfacesMibView
Snmp access group was set to guestgroup version v3 level authentication,
readview interfacesMibView, context match:exact, nonvolatile.
This example shows how to specify the target addresses:
Console> (enable) set snmp notify notifytable1 tag routers trap
Snmp notify name was set to notifytable1 with tag routers notifyType trap, and storageType
nonvolatile.
These examples show how to set the snmpTargetAddrEntry in the target address table:
Console> (enable) set snmp targetaddr router_1 param p1 172.20.21.1
Snmp targetaddr name was set to router_1 with param p1
ipAddr 172.20.21.1, udpport 162, timeout 1500, retries 3, storageType nonvolatile.
Console> (enable) set snmp targetaddr router_2 param p2 172.20.30.1
Snmp targetaddr name was set to router_2 with param p2
ipAddr 172.20.30.1, udpport 162, timeout 1500, retries 3, storageType nonvolatile.
These examples show how to set the SNMP target parameters:
Console> (enable) set snmp targetparams p1 user guestuser1 security-model v3
message-processing v3 authentication
Snmp target params was set to p1 v3 authentication, message-processing v3,
user guestuser1 nonvolatile.
Console> (enable) set snmp targetparams p2 user guestuser2 security-model v3
message-processing v3 privacy
Snmp target params was set to p2 v3 privacy, message-processing v3,
user guestuser2 nonvolatile.
These examples show how to configure guestuser1 and guestuser2 as users:
Console> (enable) set snmp user guestuser1 authentication md5 guestuser1password privacy
privacypasswd1
Snmp user was set to guestuser1 authProt md5 authPasswd guestuser1password privProt des
privPasswd
privacypasswd1 with engineid 00:00:00:09:00:10:7b:f2:82:00:00:00 nonvolatile.
Console> (enable) set snmp user guestuser2 authentication sha guestuser2password
Snmp user was set to guestuser2 authProt sha authPasswd guestuser2password privProt
no-priv with engineid
00:00:00:09:00:10:7b:f2:82:00:00:00 nonvolatile.
These examples show how to set guestuser1 and guestuser2 as members of the groups guestgroup and
mygroup:
Console> (enable) set snmp group guestgroup user guestuser1 security-model v3
Snmp group was set to guestgroup user guestuser1 and version v3, nonvolatile.
Console> (enable) set snmp group mygroup user guestuser1 security-model v3
Snmp group was set to mygroup user guestuser1 and version v3, nonvolatile.
Console> (enable) set snmp group mygroup user guestuser2 security-model v3
Snmp group was set to mygroup user guestuser2 and version v3, nonvolatile.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
47-18
OL-8978-04