Cisco WS-C6506 Software Manual page 519

Chapter 15 Configuring Access Control
To display the IP phone information that has been detected on a port on which downloaded ACLs are
present, perform this task in enable mode:
Task
Display the IP phone information on a
port.
This example shows how to display host information on a port:
Port
----- ------------------------------
3/45
To display the ACL name downloaded for a feature in addition to the port-specific information, perform
this task in enable mode:
Task
Display the ACL name downloaded for a
feature and port-specific information.
This example shows how to display the ACL name downloaded for a feature and port-specific
information:
Console> (enable) show port dot1x 3/45
Port
----- ------------------- ---------- ------------------- -------------
3/45 authenticated
Port
----- ------------- -----------------
3/45 SingleAuth
Port
----- ------------- --------------- ------------------ ---------------
3/45 -
Port
----- ------------------------ -------------------------------
3/45 disabled
Port
----- --------
3/45 disabled
Port
----- -------------------------------------------
3/45 #ACSACL#-IP-testacl-44c7197a
OL-8978-04
IP Address
10.1.1.5
Auth-State BEnd-State Port-Control
idle
Port-Mode Re-authentication
disabled
Posture-Token Critical-Status Termination action Session-timeout
no
Session-Timeout-Override Url-Redirect
Critical Port-Name
---------
-
Downloaded ACL
Command
show security acl downloaded-acl ipphone-map
Command
show port [dot1x| web-auth | eou | mac-auth-bypass ]
mod/port
auto
Shutdown-timeout
----------------
disabled
NoReAuth
-
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Downloadable ACLs
Port-Status
authorized
Control-Mode
admin oper
---------------
Both Both
-
15-123