Cisco WS-C6506 Software Manual page 510

Configuring Policy-Based Forwarding
set security acl map .gGATEWAY-TEST 1
!
<SNIP>
Console> (enable)
Looking at the above configuration, it is not obvious that the following three commands were used to
create the adjacency and security ACLs on the switch:
•
•
•
This problem is further complicated as more and more PBF clients and PBF maps are added to the
configuration. It is also not obvious which commands were used to clear the PBF configurations. In the
PBF map for the above configuration, the clear commands are as follows:
•
•
•
Listing the set and clear commands for the PBF clients, PBF gateways, and PBF maps, allows you to
manage, configure, and use the PBF map feature.
Configuring PBF in Software Release 8.6(1) and Later Releases
To configure PBF with a software release before release 8.6(1), follow these steps:
Configure the PBF MAC address for the PFC and enable PBF.
Step 1
Console> (enable) set pbf
Operation successful.
Console> (enable) show pbf
Pbf status
------------
ok
Configure one PBF client called CLIENT-TEST.
Step 2
Console> (enable) set pbf client CLIENT-TEST 10.0.0.10 00-00-11-11-22-22 10
Commit operation successful.
Console> (enable) show pbf client
Name
Map
VLAN
Clients
Adjacency
-------------------------------------------------
.c0000CLIENT-TEST
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
15-114
Unrelated configuration information cut out
set pbf client CLIENT-TEST 10.0.0.10 00-00-11-11-22-22 10
set pbf gateway GATEWAY-TEST 10.0.0.100 255.255.255.0 11-11-22-22-33-33 1
set pbf-map CLIENT-TEST GATEWAY-TEST
clear pbf client CLIENT-TEST 10.0.0.10
clear pbf gateway GATEWAY-TEST 10.0.0.100
clear pbf-map CLIENT-TEST GATEWAY-TEST
Mac address
------------------
00-0d-65-35-ed-83
: CLIENT-TEST
: No map
: 10
: 1
ip
10.0.0.10
Vlans
------------------
mac
00-00-11-11-22-22
Chapter 15 Configuring Access Control
OL-8978-04