Default GVRP Configuration
Default GVRP Configuration
Table 17-1
Table 17-1
Feature
GVRP global enable state
GVRP per-trunk enable state
GVRP dynamic creation of VLANs
GVRP registration mode
GVRP applicant state
GARP timers
1. STP = Spanning Tree Protocol
GVRP Configuration Guidelines
This section describes the guidelines for configuring GVRP:
•
•
•
•
Configuring GVRP on the Switch
These sections describe how to configure GVRP:
•
•
•
•
•
•
•
•
•
•
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
17-2
shows the default GVRP configuration.
GVRP Default Configuration
You can configure the per-port GVRP state only on the 802.1Q-capable ports.
You must enable GVRP on both ends of an 802.1Q trunk link.
The GVRP registration mode for VLAN 1 is always fixed and is not configurable.
When VTP pruning is enabled, it runs on all the GVRP-disabled 802.1Q trunk ports.
Enabling GVRP Globally, page 17-3
Enabling GVRP on Individual 802.1Q Trunk Ports, page 17-3
Enabling GVRP Dynamic VLAN Creation, page 17-4
Configuring GVRP Registration, page 17-5
Configuring GVRP VLAN Declarations from Blocking Ports, page 17-6
Setting the GARP Timers, page 17-7
Displaying GVRP Statistics, page 17-8
Clearing GVRP Statistics, page 17-8
Disabling GVRP on Individual 802.1Q Trunk Ports, page 17-8
Disabling GVRP Globally, page 17-9
Default Value
Disabled
Disabled on all ports
Disabled
normal, with VLAN 1 set to fixed, for all ports
normal (ports do not declare VLANs when in the STP
blocking state)
Join time: 200 ms
•
Leave time: 600 ms
•
Leaveall time: 10,000 ms
•
Chapter 17
Configuring GVRP
1
OL-8978-04