Detaching An Acl From An Interface - Cisco WS-C6506 Software Manual

Chapter 52 Configuring QoS
This example shows how to attach an ACL named test2 to VLAN 1 to filter the egress traffic:
Console> (enable) set qos acl map test2 1 output
ACL test2 is successfully mapped to vlan 1 on output side.
Console> (enable)
The default ACLs do not need to be attached to any interfaces.
Note

Detaching an ACL from an Interface

Supervisor Engine 1 with a Layer 2 Switching Engine does not support the commands in this section.
Note
To detach an ACL from a port or a VLAN, perform this task in privileged mode:
Task
Step 1 Detach an ACL from an interface.
Step 2 Verify the configuration.
Only PFC3 supports the input and output keywords.
Note
This example shows how to detach an ACL named my_acl from port 2/1:
Console> (enable) clear qos acl map my_acl 2/1
Hardware programming in progress...
ACL my_acl is detached from port 2/1.
Console> (enable)
This example shows how to detach an ACL named my_acl from VLAN 4:
Console> (enable) clear qos acl map my_acl 4
Hardware programming in progress...
ACL my_acl is detached from vlan 4.
Console> (enable)
The default ACLs cannot be detached from any interfaces.
Note
OL-8978-04
Command
clear qos acl map acl_name {mod/port [input] |
vlan [input | output] | all}
show qos acl map {config | runtime} {acl_name
| mod/port | vlan | all}
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-57