Default Nde Configuration - Cisco WS-C6506 Software Manual

Default NDE Configuration

Table 16-4 NDE Version 7 Flow Record Format (continued)
Bytes Content Description
14–15 output Egress interface SNMP ifIndex
16–19 dPkts Packets in the flow
20–23 dOctets Octets (bytes) in the flow
24–27 First SysUptime at start of the flow
(milliseconds)
28–31 Last SysUptime at the time the
last packet of the flow was received
(milliseconds)
32–33 srcport Layer 4 source port number or equivalent
34–35 dstport Layer 4 destination port number
or equivalent
36 flags Flow mask in use
37 tcp_flags Cumulative OR of TCP flags
38 prot Layer 4 protocol
(for example, 6=TCP, 17=UDP)
39 tos IP type-of-service byte
40–41 src_as Autonomous system number of the source,
either origin or peer
42–43 dst_as Autonomous system number of the
destination, either origin or peer
44 src_mask Source address prefix mask bits
45 dst_mask Destination address prefix mask bits
46–47 pad2 Pad 2 uses two bytes
48–51 MLS RP IP address of MLS router
1. This flow mask is not configurable from the CLI. It is only turned on if certain features, such as reflexive ACLs, are set up.
2. This feature is not supported on Supervisor Engine 1 or 1A.
3. For switched entries.
Default NDE Configuration
Table 16-5
Table 16-5
Feature
NDE
NDE data collector address and UDP port
NDE filters
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
16-6
shows the default NDE configuration.
Default NDE Configuration
Flow masks: X=Populated
Destination
Destination Source
X X
X X
X X
X X
X X
0 0
0 0
X X
0 0
0 0
X X
0 0
0 0
0 0
0 0
3 2
X X
Default Value
Disabled
None specified
None configured
Chapter 16 Configuring NDE
1
Full Full VLAN
X X
X X
X X
X X
X X
X X
X X
X X
0 0
X X
X X
0 0
0 0
0 0
0 0
2 2
X X
OL-8978-04