Cisco WS-C6506 Software Manual page 1286

Configuring QoS on the Switch
Creating or Modifying the Default IPX and MAC ACLs
PFC3 does not provide QoS for IPX traffic.
Note
To create or modify the default IPX or MAC ACL, perform this task in privileged mode:
Task
Step 1 Create or modify the default IPX or MAC ACL.
Step 2 Verify the configuration.
For more information, see the
This example shows how to modify the default IPX ACL:
Console> (enable) set qos acl default-action ipx dscp 5 aggregate my-agg
QoS default-action for IPX ACL is set successfully.
Console> (enable)
Note The IPX and MAC ACLs do not support the microflow policers.
Deleting a Named ACL
To delete a named ACL, perform this task in privileged mode:
Task
Step 1 Delete a named ACL.
Step 2 Verify the configuration.
This example shows how to delete the ACL named icmp_acl:
Console> (enable) clear qos acl icmp_acl 1
ACL icmp_acl ACE# 1 is deleted.
icmp_acl editbuffer modified. Use 'commit' command to apply changes.
Console> (enable)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
52-54
Command
With a PFC:
set qos acl default-action {ipx | mac} {dscp
dscp | trust-cos} [aggregate aggregate_name]
With PFC2:
set qos acl default-action {ipx | mac} aggregate
aggregate_name
With PFC3:
set qos acl default-action mac aggregate
aggregate_name
show qos acl info default-action {ip | ipx | mac |
all}
"Default ACLs" section on page
Command
clear qos acl acl_name [editbuffer_index]
show qos acl info {acl_name | all}
Chapter 52 Configuring QoS
52-22.
OL-8978-04