Deleting A Cos Value To A Host Destination Mac Address/Vlan Pair; Enabling Or Disabling Microflow Policing Of Bridged Traffic - Cisco WS-C6506 Software Manual

Configuring QoS on the Switch
This example shows how to map CoS 2 to a destination MAC address and VLAN 525:
Console> (enable) set qos mac-cos 00-40-0b-30-03-48 525 2
CoS 2 is assigned to 00-40-0b-30-03-48 vlan 525.
Console> (enable)

Deleting a CoS Value to a Host Destination MAC Address/VLAN Pair

QoS supports this command only with a Layer 2 Switching Engine.
Note
To delete a host destination MAC address and VLAN number value pair CoS assignment, perform this
task in privileged mode:
Task
Step 1 Delete a host destination MAC address and VLAN
number value pair CoS assignment.
Step 2
Verify the configuration.
This example shows how to delete all CoS assignments to the destination MAC addresses and VLANs:
Console> (enable) clear qos mac-cos all
All CoS to Mac/Vlan entries are cleared.
Console> (enable)

Enabling or Disabling Microflow Policing of Bridged Traffic

Note Supervisor Engine 1 with a Layer 2 Switching Engine does not support the commands in this section.
By default, the microflow policers affect only the Layer 3-switched traffic. To enable or disable
microflow policing of the bridged traffic on the switch or on specified VLANs, perform one of these
tasks in privileged mode:
Task
Enable microflow policing of the bridged traffic
on the switch or on the specified VLANs.
Disable microflow policing of the bridged traffic
on the switch or on the specified VLANs.
Verify the configuration.
With Layer 3 Switching Engine II, to do any microflow policing, you must enable microflow policing
Note
of the bridged traffic.
For more information, see the
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
52-62
Command
clear qos mac-cos {dest_mac [vlan] | all}
show qos mac-cos {dest_mac [vlan] | all}
Command
set qos bridged-microflow-policing {enable |
disable} vlan
set qos bridged-microflow-policing {enable |
disable} vlan
show qos bridged-microflow-policing runtime
{config | runtime} vlan
"Policers" section on page
Chapter 52
52-24.
Configuring QoS
OL-8978-04