Configuring Snmpv1 And Snmpv2C On The Switch; Snmpv1 And Snmpv2C Default Configuration; Configuring Snmpv1 And Snmpv2C From An Nms; Configuring Snmpv1 And Snmpv2C From The Cli - Cisco WS-C6506 Software Manual

Chapter 47 Configuring SNMP

Configuring SNMPv1 and SNMPv2c on the Switch

This section provides the basic SNMPv1 and SNMPv2c configuration information. For detailed
information on the SNMP commands that are supported by the Catalyst 6500 series switches, refer to
the Catalyst 6500 Series Switch Command Reference publication.

SNMPv1 and SNMPv2c Default Configuration

Refer to the Catalyst 6500 Series Switch Command Reference for the SNMP default configuration
settings for each command that is listed in the configuration section.

Configuring SNMPv1 and SNMPv2c from an NMS

To configure SNMP from an NMS, refer to the NMS documentation (see the
section on page
The switch supports up to 20 trap receivers through the RMON2 trap destination table. You configure
the RMON2 trap destination table from the NMS.

Configuring SNMPv1 and SNMPv2c from the CLI

For the enhanced SNMP features in software release 7.5(1), see the
Note
Enhancements in Software Release 7.5(1)" section on page
To configure SNMP from the CLI, perform this task in privileged mode:
Task
Step 1 Define the SNMP community strings for each
access type.
Step 2 Assign a trap receiver and community. You can
specify up to ten trap receivers.
Step 3
Specify the SNMP traps to send to the trap
receiver.
Step 4 Verify the SNMP configuration.
OL-8978-04
47-6).
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring SNMPv1 and SNMPv2c on the Switch
"Using CiscoWorks2000"
"SNMPv1 and SNMPv2c
47-12.
Command
set snmp community read-only
community_string
set snmp community read-write
community_string
set snmp community read-write-all
community_string
set snmp trap rcvr_address rcvr_community
set snmp trap enable [all | auth | bridge | chassis
| config | entity | entityfru | envfan | envpower |
envshutdown | envtemp | flashinsert |
flashremove | ippermit | module | stpx | syslog |
system | vlancreate | vlandelete | vmps | vtp]
show snmp
47-11