Cisco WS-C6506 Software Manual page 1382

Troubleshooting the ASLB Configuration
Table 54-6 Troubleshooting the ASLB Configuration (continued)
Symptom
LocalDirector set commands did not take
effect.
You see "collisions" or "port disabled"
on the Catalyst 6500 series switch port.
1. CDP = Cisco Discovery Protocol
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
54-26
Recommended Action
The set lda commands do not take effect until you enter the commit lda
command.
You can verify which set lda commands are in effect by entering the show lda
commit command.
You can determine which set lda commands are set but not committed or what
changes will occur if the current set lda commands are committed by entering the
show lda uncommitted command.
Ensure that the port speed and duplex settings are compatible on both ends of the
link between the LocalDirector and the switch. For example, if port 3/7 on the
switch is connected to interface ethernet 0 on the LocalDirector, make sure that
port 3/7 is set to 100full and that interface ethernet 0 on the LocalDirector is also
set to 100full.
Chapter 54 Configuring ASLB
OL-8978-04