Cisco WS-C6506 Software Manual page 1283

Chapter 52 Configuring QoS
This example shows how to modify the default IP ACL:
Console> (enable) set qos acl default-action ip dscp 5 microflow my-micro aggregate my-agg
QoS default-action for IP ACL is set successfully.
Console> (enable)
Modifying the Default IP Egress ACL
Only PFC3 supports the configuration commands in this section.
Note
To modify the default IP egress ACL, perform this task in privileged mode:
Task
Step 1
Modify the default IP ACL.
Step 2 Verify the configuration.
In the default egress ACL, the trust-dscp keywords cause the ACL to trust the internal DSCP value, not
Note
a received DSCP value (see the
For more information, see the
This example shows how to modify the default IP ACL:
Console> (enable) set qos acl default-action ip dscp 5 microflow my-micro aggregate my-agg
QoS default-action for IP ACL is set successfully.
Console> (enable)
Creating or Modifying the Named IPX ACLs
PFC3 does not provide QoS for the IPX traffic. See the
Note
section on page 52-21
OL-8978-04
"Internal DSCP Values" section on page
"Default ACLs" section on page
for information about how to use the MAC ACLs to filter the IPX traffic.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
Command
set qos acl default-action ip {dscp dscp |
trust-dscp} [aggregate aggregate_name] output
show qos acl info default-action ip
52-16).
52-22.
"MAC ACE Layer 2 Classification Criteria"
52-51