Rspan Configuration Examples - Cisco WS-C6506 Software Manual

Chapter 49 Configuring SPAN, RSPAN and the Mini Protocol Analyzer
This example shows how to disable one source session by rspan_vlan number:
Console> (enable) set rspan disable source 903
Disabled monitoring of all source(s) on the switch for rspan_vlan 903.
Console> (enable)
This example shows how to disable all the enabled destination sessions:
Console> (enable) set rspan disable destination all
This command will disable all remote span destination session(s).
Do you want to continue (y/n) [n]? y
Disabled monitoring of remote span traffic for all rspan destination ports.
Console> (enable)
This example shows how to disable one destination session by mod/port:
Console> (enable) set rspan disable destination 4/1
Disabled monitoring of remote span traffic on port 4/1.
Console> (enable)

RSPAN Configuration Examples

These sections describe how to configure RSPAN:
•
•
•
•
•
Configuring a Single RSPAN Session
This example shows how to configure a single RSPAN session.
configuration; see
that you have already set up RSPAN VLAN 901 for this session on all the switches using the set vlan
vlan rspan command. With VTP enabled in the network, you can create the RSPAN VLAN in one switch
and VTP propagates it to the other switches in the VTP domain. Note that in the configuration example
shown in
the configuration in Switch C or Switch D.
OL-8978-04
Configuring a Single RSPAN Session, page 49-15
Modifying an Active RSPAN Session, page 49-16
Adding the RSPAN Source Ports in Intermediate Switches, page 49-17
Configuring Multiple RSPAN Sessions, page 49-17
Adding Multiple Network Analyzers to an RSPAN Session, page 49-19
Table 49-2
Table 49-2, the RSPAN session may be disabled in Switch A or B or both without modifying
for the commands to configure this RSPAN session.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring RSPAN on the Switch
Figure 49-3 shows an RSPAN
Table 49-2 assumes
49-15