Cisco WS-C6506 Software Manual page 1226

Configuring RGMP on the Switch
This example shows how to display only the RGMP-capable router ports:
Console> (enable) show multicast router rgmp
Port
-------------- ----------------
2/2
16/1
Total Number of Entries = 2
'*' - Configured
'+' - RGMP-capable
'#' - Channeled Port
'$' - IGMP-V3 Router
'@' - IGMP-Querier Router
Console> (enable)
Clearing RGMP Statistics
This command clears the stored RGMP statistics.
To clear the RGMP statistics, perform this task in privileged mode:
Task
Clear the RGMP statistics.
This example shows how to clear the RGMP statistics:
Console> (enable) clear rgmp statistics
RGMP statistics cleared.
Console> (enable)
RGMP-Related CLI Commands
This command enables or disables the RGMP-related commands from the router.
To enable or disable RGMP, perform one of these tasks in configuration mode:
Task
Enable RGMP.
Disable RGMP.
This command enables or disables RGMP debugging.
To enable or disable RGMP debugging, perform one of these tasks in privileged mode:
Task
Enable RGMP debugging.
Disable RGMP debugging.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
51-34
Vlan
+ @ 40
+ @ 200
Chapter 51 Configuring Multicast Services
Command
clear rgmp statistics
Command
Router(config)# ip rgmp
Router(config)# no ip rgmp
Command
Router# debug ip rgmp [group-name |
group-address]
Router# no debug ip rgmp [group-name |
group-address]
OL-8978-04