Configuring Aslb From The Cli - Cisco WS-C6506 Software Manual

Chapter 54 Configuring ASLB

Configuring ASLB from the CLI

This section describes how to configure ASLB using the Catalyst 6500 series switch lda command set:
•
•
•
•
•
•
•
•
•
•
•
•
•
Configuring the Switch Ports Connected to the LocalDirector
To configure the 10/100-Ethernet switch ports that are connected to the LocalDirector, perform these
steps:
Enter the set vlan vlan_num mod_ports command to add the switch ports to the correct VLANs (router
Step 1
VLAN and server VLAN).
Note that the port speed and duplex type for the switch ports do not need to be set as all 10/100-switch
Step 2
ports are set to autonegotiate as the default. If you have a problem with autonegotiation, configure the
port speed and duplex type as follows:
Enter the set port speed mod/port {10 | 100 | auto} command to set the port speed.
Enter the set port duplex mod/port {full | half | auto} command to set the type of duplex.
Enabling and Disabling ASLB
ASLB is disabled by default. When ASLB is disabled, you cannot enter the set lda commands to perform
Note
configuration tasks; to enter the set lda commands, you must enable ASLB.
To enable or disable ASLB, perform this task in privileged mode:
Task
Enable or disable ASLB.
OL-8978-04
Configuring the Switch Ports Connected to the LocalDirector, page 54-11
Enabling and Disabling ASLB, page 54-11
Specifying the Server Virtual-IP Addresses and TCP Ports for Acceleration, page 54-12
Specifying the MAC Addresses for Participating Routers, page 54-12
Specifying a MAC Address for the LocalDirector, page 54-13
Specifying the Router VLAN and the LocalDirector Port on the VLAN, page 54-13
Specifying the Server VLAN and the LocalDirector Port on the VLAN, page 54-14
Configuring the UDP Aging, page 54-14
Committing the ASLB Configuration, page 54-14
Displaying the ASLB Configuration, page 54-15
Displaying the ASLB MLS Entries, page 54-16
Displaying the ASLB MLS Statistics, page 54-17
Clearing the ASLB Configuration, page 54-17
Command
set lda enable | disable
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring ASLB on the Switch
54-11